 |
ApplicationEPI NEMA Type 4 Wall Mount Enclosures are designed to house electrical controls, terminals, and instruments in areas which are regularly hosed down, or are very wet environments. |
| ConstructionMade from 14, 12, or 10 gauge steel. All seams are continuously welded. There are no holes or knockouts. A lip is provided on three sides of the door, increasing strength and preventing dirt and liquids from dropping into the enclosure. The neoprene door gasket is attached with oil-resistant adhesive. The door clamps are quick and easy to operate, and have no loose parts. Exterior clamps, clamp screws, and hinge-pin are stainless steel. A hasp and staple are provided for padlocking. Body stiffeners and door stiffeners are provided in larger enclosures for extra rigidity. External feet are provided for mounting. Mounting brackets are provided for optional mounting panel, otherwise, not installed.FinishThe standard finish is ANSI-70 light dove gray enamel, inside and out. Panels are the same. Other finishes are available for specific application.AccessoriesPanels must be ordered separately as they are not furnished. Floor stand kits in 6, 12, 18, and 24 inch heights are available for factory installation on all single door NEMA 4 enclosures. Drip shield kits protect the door hardware from dripping water and settling dust.StandardsMeets National Electrical Manufacturers Association (NEMA) standard for Type 4 (Water Tight and Dust Tight) enclosures. Also conforms to the Joint Industrial Council (JIC) Standard EGP-1-1967. UL50 |
