 |
ApplicationEPI NEMA Type 4 Double Door Floor Mounted Enclosures are designed to house electrical controls, terminals, and instruments in areas which may be regularly hosed down or are otherwise very wet. |
| ConstructionMade from 14,12, or 10 gauge steel. All seams are continuously welded and there are no holes or knockouts. A lip is provided around three sides of the door. This lip increases strength and keeps dirt and liquids from dropping into the enclosure. Clamps are provided on three sides of each door to insure a watertight seal with neoprene gaskets. The gaskets are attached with oil-resistant adhesive. All exterior hardware (such as clamps, clamp screws, hinge pins, etc.) is stainless steel. A heavy gauge continuous hinge supports each door. The center post is not removable. A hasp and staple are provided on each door for padlocking. Each enclosure has 12 inch floor stands and body stiffenersFinishThe standard finish for enclosures and panels is ANSI-70 painted light dove gray enamel inside and out. Other finishes are available for specific applications.AccessoriesPanels must be ordered separately as they are not furnished. Floor stand kits in 6, 12, 18, and 24 inch heights are available for factory installation on all two door NEMA 4 enclosures. Drip shield kits protect the door hardware from dripping water and settling dust.StandardsMeets National Electrical Manufacturers Association (NEMA) standard for Type 4 (Water Tight and Dust Tight) enclosures. Also conforms to the Joint Industrial Council (JIC) standard EGP-1-1967. UL50. |
